INT RUNDOWN TABLE

The following table tells the auditor and C/S which way to go when handling Out-Int. Once filled out this table should be kept with the pc Folder Summary in front inside of the pc folder beneath the program. And the table should be updated.
 
Simply fill in with Yes/ No
 

A. IS THE READ ON INT A VALID READ? ____ ____

Is there any evidence of the pc having been run on Int due to a false or protest read? ____ ____
 
Any evidence of the read being caused by a MU word? ____ ____
 
(If ‘yes' on above get ‘False read?' and ‘Protest?' cleaned up or the Mis-U cleared and recheck the buttons on Section A of C/S 53 to find out if Int is charged.)
 
B. HAS THE PC HAD A FULL INT RUNDOWN? ____ ____
 
(If ‘no' or incomplete, it would have to be repaired and completed. NOTE: The Int RD would NOT be run on a Clear or above as they are not to be run on Engrams.)
 
C. HAS THE PC HAD AN INT RUNDOWN CORRECTION LIST? ____ ____
 
(If not, and there is any evidence of errors or lack of expected result, this should be done before continuing the Engrams Int RD or doing the Recall Int Rundown. And if the pc has had several Int Rundown Correction Lists, realize that either the auditor can't make a list read, or is only getting false reads.)
 
D. HAVE ANY R3R OR R3RA ENGRAM ERRORS ON THE INT RUNDOWN BEEN CORRECTED WITH AN L3RH? ____ ____
 
(If not, get these repaired, as continuing the RD, or doing Recall Int Rundown won't solve R3R or R3RA errors.)
 
 
E. IS THE PC CLEAR OR ABOVE? ____ ____
 
Was the pc Clear when the Int RD was run on him by R3R or R3RA ? ____ ____
 
(If ‘yes' to either above, you must not run any Engrams but if Int is still out after repairing any errors the Recall Int Rundown can be done on a Clear.
 
If the pc was run on Engrams on the Int RD after Clear, the first action is to indicate the error of running Engrams after Clear, and then repair any reading Engram Int Chain with an L3RH, taking care to handle the reading lines by indication only, and not get into any running of Engrams. This action alone will often cure any Int trouble on a Clear, but if Int is still reading you can now handle it with the Recall Int Rundown.)