RECALL INT RD CORRECTION LIST

This list only covers errors on Recall Int Rundown. It does not cover Int RD done with Engram running. The purpose of this list is to correct an unflat, overrun or otherwise messed up Int Handling when the pc's TA either high or low. Only valid on pc's who has had an Recall Int RD. Does not cover pc's that had Int Handling with Engram running. The list is used:

(a) When a repair list with the subject of INT-EXT on it reads, and the Recall Int R/D has already been done or corrected and the TA is high or low.
 
(b) When a bog occurs in the Recall Int R/D itself.
 
(c) If the pc is upset after the Recall Int R/D, and/or TA has gone high or low; or when pc is not VGIs on Going into things.

Assess this list Method 3.
 Take up each  read to F/N and get the reading item fully repaired to F/N. This list is laid out in the sequence the reads are to be handled. Suppress and False can be used as needed to take a question to F/N. Handle each read to F/N, do not go on to another question leaving one that has not F/N'ed.
Do however not take the list beyond a major win as that would be the EP of repair.

R-FACTOR. We are going to do an Assessment concerning your Int Handling.
 
1. ON YOUR INT HANDLING IS A RECALL FLOW UNFLAT _________
        If so, get Int buttons run (from folder) and assess:
               Is "Recall a time when you (Int button)"  unflat? 
               Is "Recall a time when you caused another (Int button)"  unflat? 
               Is "Recall a time when others caused others (Int button)"  unflat? 
               Is "Recall a time when you caused yourself (Int button)"  unflat? 

Take up unflat flow and run to EP. Then run/F/N the other flows for that button.
Then reassess buttons as the R/D may be unflat. Take to EP.

2. WAS SOME PART OF YOUR INT HANDLING MISRUN _________
        Find out what. Indicate BPC. Handle unflat flows per #1 above.

3. DID YOU RUN THE CONCEPT OF "BEING IN" OR "BEING STUCK IN" INSTEAD OF "GOING IN" _________
    Sort it out. Find what was run. If you find pc wasn't running "Going in" (or actual button assessed), check that button for read. If it reads now, flatten the recall flows and the whole R/D to EP.

4. WERE YOU RUNNING AN ITEM THAT WAS DIFFERENT THAN THE ONE ASSESSED ________
    Indicate it. Get item pc actually ran. If a valid button take to full EP (4 flows). Now recheck the item assessed. Put in Suppress and Invalidate if needed. If charged run this item to EP and flatten R/D.

5. DID THE INT BUTTON ASSESSED HAVE NO CHARGE ON IT __________
    Indicate the button was uncharged and shouldn't have been run. All actions in connection with it should not have been done. This may F/N. Date/Locate when it was all fine (before the unnecessary action) if needed.

6. WAS THERE ANOTHER BUTTON THAT SHOULD HAVE READ ___________
    Get which. Note read when pc says it. Sort out if the Int button taken up was charged. If so flatten to F/N.
    If not, handle per #5. Handle new button to EP if charged.

7. ON YOUR INT  WERE YOU RUN ON A RECALL FLOW THAT HAD NO CHARGE ON IT ________
    Get which. Indicate that flow should not have been run.

8. CAN'T YOU GET IN _________
If charged, do L&N "Who of What was afraid to go into things?" Run O/W 
    (1) "What did (item) do?", (2) What did (item) withhold?" to F/N and a blow.

9. DO YOU HAVE AN OUT LIST _________
    Sort out with L4BRB.

10. WAS THE R/D DONE OVER AN ARC BREAK ________
                                                                PROBLEM _________
                                                              WITHHOLD _________
                                                                      OVERT _________
    Indicate and handle the out rud.

11. WAS THE R/D DONE OVER SOME OTHER BY-PASSED CHARGE _________
    Find out what and handle.

12. WAS THE WORDING OF THE R/D BADLY CLEARED ________
    Fully clear up all MU's to F/N.

13. ON YOUR INT HANDLING WAS THERE A MISUNDERSTOOD WORD _________
    Fully clear up all MUs to F/N.

14. WERE YOU CONFUSED ABOUT S/G ___________
    Clear up with definitions or reference. TWC E/S to F/N.

15. DIDN'T UNDERSTAND WHAT THE R/D WAS FOR __________
    Clear up with definitions or reference. TWC E/S to F/N.

16. WERE YOU THINKING OF LEAVING DURING INT ________
        TWC E/S to F/N.

17. WERE YOU LEAVING A POST OR JOB ___________
       TWC E/S to F/N.

18. WERE YOU TRYING TO GET A POST OR JOB _________
        TWC E/S to F/N.

19. A/G TO DO WITH JAILS ____________
        TWC E/S to F/N.

20. ARE YOU WANTED ANYWHERE ____________
        TWC E/S to F/N.

21. ARE YOU AFRAID THAT IF YOU GET OUT YOU WILL CAUSE DAMAGE ___________
        TWC E/S to F/N.

22. WOULD LETTING YOU OUT BE AN OVERT ____________
        TWC E/S to F/N.

23. HAVE YOU FAILED TO GET OUT IN AN EARLIER RELIGION OR PRACTICE __________
        TWC E/S to F/N. (Note to C/S for further handling)

24. DO YOU JUST MOVE BACK INTO THE BODY AND PUSH AGAINST IT __________
        TWC E/S to F/N.

25. WERE THERE AUDITOR ERRORS ____________
    Indicate. Sort it out and handle BPC. L1C M3 if necessary and TA in range.
        

26. WERE YOU AUDITED ON ENGRAMS AFTER GOING CLEAR __________
        Indicate as BPC. (Do not tell pc "You went Clear"). Get to F/N. Note full data for C/S.

27. HAS INT BEEN NEGLECTED FOR A LONG TIME ___________
        Indicate. TWC E/S to F/N.

28. ARE YOU WORRIED BECAUSE INT CONTINUES TO READ _________
        Indicate. TWC E/S to F/N.

29. ARE YOU CONCERNED BECAUSE YOU HAVE TO BE REPAIRED _________
        Indicate. TWC E/S to F/N.

30. WAS THE INT HANDLING ALREADY FLAT ____________
        Indicate. Date/Locate the flat point.

31. WAS YOUR INT HANDLING OVERRUN ______________
        Indicate. Date/Locate the flat point. ("Felt good about going into things").

32. WAS THE INT HANDLING UNNECESSARY IN THE FIRST PLACE __________
        Indicate. If no F/N, Date/Locate the point pc "Felt good about going into things".

33. DID YOU FEEL FINE ABOUT GOING INTO THINGS TO BEGIN WITH __________
        Indicate. If no F/N, Date/Locate the prior flat point.

34. IS YOUR INT HANDLING PERFECTLY OK _____________
        Indicate. If no F/N, Date/Locate the point pc "Felt good about going into things".

35. HAS YOUR INT HANDLING BEEN OVER-REPAIRED __________
        Indicate. Date/Locate the flat point.

36. HAS INT BEEN RUN SEVERAL TIMES OVER ___________
        Indicate. Date/Locate the flat point.

37. HAS THE INT R/D CORRECTION LIST  BEEN OVERDONE ____________
        Indicate. If no F/N, Date/Locate the point pc felt the R/D was repaired.

38. ON YOUR INT HANDLING DID YOU GO PAST A WIN ___________
        Indicate. Rehab win to F/N VGIs. If no F/N, Date/Locate that point.

39. DURING YOUR INT HANDLING DID YOU GO EXTERIOR _______
        Indicate. Rehab to F/N VGIs. If no F/N, Date/Locate that point.

40. IS THIS ACTION UNNECESSARY ___________
        Indicate. If no F/N, TWC E/S TWC to F/N.

41. IS THERE S/G ELSE WRONG?
        Find out what and handle.